'Triangle' button n...
 
Notifications
Clear all

'Triangle' button not working

11 Posts
2 Users
0 Likes
970 Views
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

 Here is the picture of the control/power board. All three arrows are connected together.


   
Quote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

After checking with my meter, it is pin 4 on the zif connector on the controller board. 


   
ReplyQuote
othermod
(@othermod)
Reputable Member Admin
Joined: 8 years ago
Posts: 360
 

The left arrow and top-right arrow are always connected together, but the middle one shouldn't be. Any chance you can get a pic of the pins on the FPC connector?


   
ReplyQuote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

On your board correct?

 


   
ReplyQuote
othermod
(@othermod)
Reputable Member Admin
Joined: 8 years ago
Posts: 360
 

Exactly. My board.


   
ReplyQuote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

Here it is:


   
ReplyQuote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

It would be this pin correct?:


   
ReplyQuote
othermod
(@othermod)
Reputable Member Admin
Joined: 8 years ago
Posts: 360
 

Nope, not that one. This is the connector rotated 180 degrees from the position in your pic


   
ReplyQuote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

Ok, and opps, forgot to add two lines for the right shoulder. So it would be the sixth trace from the left in my picture. I will dig deeper tomorrow and see where that trace connects to and see if it is shorted against something. Can you tell me where the triangle line goes to on your board? So that I can check.

 


   
ReplyQuote
othermod
(@othermod)
Reputable Member Admin
Joined: 8 years ago
Posts: 360
 

Same orientation. That's the right side of the GPIO header, closest to the battery compartment.


   
ReplyQuote
(@2008cbr1krr)
Member Customer
Joined: 7 years ago
Posts: 7
Topic starter  

Gotcha! Thank you so much for your help. I will look into this tomorrow. 


   
ReplyQuote