Notifications
Clear all
Topic starter
February 25, 2017 1:03 am
Hello, I'm back yet again with another question for the PSPI V2.1. I have the Audio Amplifier with the built in filter and i was a little confused on how i would go about wiring this one up since the one in the video guide Part 3 is the one without the filter. I know theres the schematic, but I still found that kind of confusing.
February 26, 2017 4:04 pm
The SHDN pin gets connected to GND to shut off the amp
Topic starter
March 7, 2017 3:26 am
Does this looks right? I just want to make sure i'm not messing anything up.
March 7, 2017 12:33 pm
Almost. Get rid of that blue wire. If you keep it connected then the amp will stay off.
