Notifications
Clear all
Nuneberg
Nuneberg
Group: Registered
Joined: August 6, 2017
Active Member
1
I hade a similar issue and was stuck. But this i what i did...

In forum Support for othermod's Boards

5 years ago
now we are getting somewhere. =D Yes i am positive the boar...

In forum Support for External Projects

5 years ago
No the m7 diode is removed and replaced with a jumper. (Piec...

In forum Support for External Projects

5 years ago
Hi. Good that means that it is hope. ;) With a input voltag...

In forum Support for External Projects

5 years ago
Hi. you are correct that the chip works with 4.75v-28v. and...

In forum Support for External Projects

5 years ago
At 12v input.. At pin nr 2 I get 11.2v Pin 3 i get 3.3v And ...

In forum Support for External Projects

5 years ago
I will try to messure.. but i think the ic is A5269 instead ...

In forum Support for External Projects

5 years ago
Do you think ut is possible to get this to work on 5v?

In forum Support for External Projects

5 years ago
I found another driver board.. If you want to give some inp...

In forum Support for External Projects

5 years ago
Here it is. Dont look at the solder wires.. ;P it's just fo...

In forum Support for External Projects

5 years ago
I dont doubt you.. but i did some testing and here is the cu...

In forum Support for External Projects

5 years ago
Thanks alot for the help so far. Yes. It is 3.3v on both s...

In forum Support for External Projects

5 years ago
On the td1519a ic i get: Pin 2: 5v Pin 3: 3,3 v Pin 7: 5v ...

In forum Support for External Projects

5 years ago
It is 5.21v one one side. And 5.17 on the other side.

In forum Support for External Projects

5 years ago
I have some bad luck with these driver boards.. =P I tried...

In forum Support for External Projects

5 years ago
I have some bad luck with these driver boards.. =P I tried...

In forum Support for External Projects

5 years ago
No the other one is new not used or modified.. I will try ...

In forum Support for External Projects

5 years ago
Hey. I have 2 of these boards.. and i tried a few things t...

In forum Support for External Projects

5 years ago